All Categories

  • All Categories
  • Arduino And SCM Supplies
  • Electronic Components
  • Capacitors
  • Electronic Component Tools
  • Passive Components
  • Motor Controls
  • Other Electrical And Test Equip

MEGA2560 R3 Microcontroller With Prototype Board + L293D Motor Drive Shield

$26.81 Ex Tax: $26.81
  • Product Code: lec170
  • Availability: In Stock
Product DescriptionDescription: MEGA2560 R3 Microcontroller Board Tested before shipment, you would receive a working board with blinking LE...

Product Description

MEGA2560 R3 Microcontroller Board
Tested before shipment, you would receive a working board with blinking LED, otherthan a board without bootloader.
Microcontroller: ATmega2560
Clock Speed: 16 MHz
Flash Memory: 256 KB of which 8 KB used by bootloader
Operating voltage: 5V
Input voltage (recommended): 7-12V
Analog Input Pins: 16
Digital I/O Pins: 54 (of which 14 provide PWM output)
DC Current for 3.3V Pin: 50 mA
DC Current per I/O Pin: 40 mA
USB serial driver use CH340G replace the Atmega 8U2/16U2
Prototype Board for MEGA2560 R3 Board
MEGA V3 Prototype Shield with small gold square pad spacing, easier for components soldering and SOP28 SMD components,come with a mini breadboard, integrated power indicator,status lights and reset button,very simple and handy.
L293d  Motor Driver Shiled/Board
Two connections for 5V Servos, connected to the Arduino's high-resolution dedicated timer – no jitter!
Able to drive 4 DC motors / 2 stepper motors / 2 Servo
Run motors on DC4.5V – DC 25V
Up to 4 bi-directional DC motors with individual 8-bit speed selection(~0.5 resolution)
Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping
4 H-Bridges L293D chip provides 0.6A/bridge (1.2A peak) with thermal shutdown protection
Built with internal kickback protection diodes.
Built with pull down resistors keep motors disabled during power-up.
Big terminal block connectors to easily hook up wires (18-26AWG) and power Arduino reset button brought up top.
2-pin terminal block and jumper to connect external power, for separate logic/motor supplies.
Size: 70 x 55mm (L x W)
Package includes:
1 x Prototype Board
1 x L293d Motor Driver Shiled
1 x MEGA2560 R3
1 x USB cable
1 x Connector
65 x DuPont cable

Write a review

Note: HTML is not translated!
    Bad           Good

Random products

Copyright © 2021,All Right Reserved.